Wall for holding wear plates and method for changing wear plates

The wall according to the invention for the assembly of the wear plates has several openings. These openings are provided for mounting and supporting the wear plates from the outside. That is, the wear plates and guided to the mounting through the wall are then attached. To mount the wear plates a gap is provided as an opening in the wall that extends to an edge of the position of the wear plate to mounted end. At right angles from the gap two slots corresponding to the bolt at the rear of the wear plate in position and dimensions extend. The inventive method for the assembly of wear plates at a wall of the invention described above has the following method steps. In a first step a) mounting one or more insertion guides takes place at one or more gap-near Befestigunsgelementen having been removed here in the subsequent step b) the Befestigusmuttern takes place the introduction of the wear plate in the gap, to the extent until the Befestigunsgelemente not spaltnah which have passed slots. Subsequently, in step c) the tilting of the wear plate in the gap, such that the gap-near Befestigunsgelemente enter the slots and the wear plate can be completely passed through the wall. In step d) is then carried the insertion of the fastening elements, which are not spaltnah, in the appropriate openings of the wall. In a final step e) the locking of the Befestigunsgelemente not spaltnah in the openings and releasing of the insertion aids from the nip close fastener elements is carried out. Advantageously according to the invention must have a component z. B. will no longer enter a chute to replace the wear plates.