Feasibility of Geiger-mode avalanche photodiodes in CMOS standard technologies for tracker detectors

The next generation of particle colliders will be characterized by linear lepton colliders, where the collisions between electrons and positrons will allow to study in great detail the new particle discovered at CERN in 2012 (presumably the Higgs boson). At present time, there are two alternative projects underway, namely the ILC (International Linear Collider) and CLIC (Compact LInear Collider). From the detector point of view, the physics aims at these particle colliders impose such extreme requirements, that there is no sensor technology available in the market that can fulfill all of them. As a result, several new detector systems are being developed in parallel with the accelerator. This thesis presents the development of a GAPD (Geiger-mode Avalanche PhotoDiode) pixel detector aimed mostly at particle tracking at future linear colliders. GAPDs offer outstanding qualities to meet the challenging requirements of ILC and CLIC, such as an extraordinary high sensitivity, virtually infinite gain and ultra-fast response time, apart from compatibility with standard CMOS technologies. In particular, GAPD detectors enable the direct conversion of a single particle event onto a CMOS digital pulse in the sub-nanosecond time scale without the utilization of either preamplifiers or pulse shapers. As a result, GAPDs can be read out after each single bunch crossing, a unique quality that none of its competitors can offer at the moment. In spite of all these advantages, GAPD detectors suffer from two main problems. On the one side, there exist noise phenomena inherent to the sensor, which induce noise pulses that cannot be distinguished from real particle events and also worsen the detector occupancy to unacceptable levels. On the other side, the fill-factor is too low and gives rise to a reduced detection efficiency. Solutions to the two problems commented that are compliant with the severe specifications of the next generation of particle colliders have been thoroughly investigated. The design and characterization of several single pixels and small arrays that incorporate some elements to reduce the intrinsic noise generated by the sensor are presented. The sensors and the readout circuits have been monolithically integrated in a conventional HV-CMOS 0.35 ?m process. Concerning the readout circuits, both voltage-mode and current-mode options have been considered. Moreover, the time-gated operation has also been explored as an alternative to reduce the detected sensor noise. The design and thorough characterization of a prototype GAPD array, also monolithically integrated in a conventional 0.35 ?m HV-CMOS process, is presented in the thesis as well. The detector consists of 10 rows x 43 columns of pixels, with a total sensitive area of 1 mm x 1 mm. The array is operated in a time-gated mode and read out sequentially by rows. The efficiency of the proposed technique to reduce the detected noise is shown with a wide variety of measurements. Further improved results are obtained with the reduction of the working temperature. Finally, the suitability of the proposed detector array for particle detection is shown with the results of a beam-test campaign conducted at CERN-SPS (European Organization for Nuclear Research-Super Proton Synchrotron). Apart from that, a series of additional approaches to improve the performance of the GAPD technology are proposed. The benefits of integrating a GAPD pixel array in a 3D process in terms of overcoming the fill-factor limitation are examined first. The design of a GAPD detector in the Global Foundries 130 nm/Tezzaron 3D process is also presented. Moreover, the possibility to obtain better results in light detection applications by means of the time-gated operation or correction techniques is analyzed too.