Structural synthesis of electrical engineering complex’ control system of a plant for plastic shaping of the ceramic mixture

Production of ceramic bricks with the required strength imposes significant restrictions on the process control of plastic shaping of the ceramic mixture in the auger extruder. It is due to several factors. Firstly, the certain nonstationarity of rheological properties of the source raw materials necessitates the automatic task-oriented changes in combinations of such values as shear rate, ceramic mixture moisture and vacuum pressure in the vacuum chamber of the extruder. To solve this problem it is necessary to maintain a coordinated control of the relevant automatic control systems of the electrical engineering complex. The second problem is the lack of technical tools to measure the values of shear rate in the pressure head of the extruder. And finally, the third factor is a necessity for monitoring and modeling of operating steps in brick production – from shaping to finished product output, that is a necessity to assess the impact of drying and firing processes on the possibility to make bricks of specified strength. The paper considers structural synthesis of the electrical engineering complex’ control system for plastic shaping of the ceramic mixture, including the problem of coordinated control: of the vacuum pump’ electrical drive, of the solenoid valve for water dosing, of the belt feeder’ electrical drives, of the mixer and the auger, as well as the use of digital observers of technological controlled coordinates and models in further phases of brick production.