Factors Affecting the Labeling of NIH 3T3 Cells with Magnetic Nanoparticles

The factors that affect the labeling of NIH 3T3 murine fibroblasts with Fe3O4-based magnetic nanoparticles (MNPs) were studied using MNPs produced by the gas condensation and solution precipitation methods and MNPs surface-modified with 3-aminopropylsilane or L-lysine. The production method, surface modifications, the particle concentration and size, the state of the cell population, and the method of MNP introduction were found to substantially affect the efficiency of MNP binding by cells. In particular, large MNP clusters may occur in MNP suspensions in DMSO, and their disruption by sonication increased the percent yield of magnetically labeled cells. Static incubation of a cell suspension led to a more efficient labeling as compared with continuous agitation. Cells attached to a plastic support could be labeled to a higher degree than cells in suspension, but required substantially longer incubations with MNPs. MNP centrifugation on cell layers (magnetic spinoculation) significantly increased the rate and efficiency of labeling. The stability of magnetic labeling was shown to depend on the MNP dose during labeling. Electron microscopy studies demonstrated that MNPs were associated with the cell surface after 20-min incubation with cells and were mostly in the cell interior after 4-h incubation. The results of the study may be useful for preparation and application of magnetized cell samples.