QbD-Based Investigation of Dermal Semisolid in situ Film-Forming Systems for Local Anaesthesia

Purpose The aim of our research work was to develop dermally applicable, lidocaine hydrochloride (LID-HCl)-containing semisolid in situ film-forming systems (FFSs) using the Quality by Design (QbD) approach to increase drug permeation into the skin. Methods Silicones were used to improve the properties of formulations and to increase the permeation through the skin. The QbD approach was applied to ensure quality-based development. With initial risk assessment, the critical material attributes (CMAs) and the critical process parameters (CPPs) were identified to ensure the required critical quality attributes (CQAs). Results During the initial risk assessment, four high-risk CQAs, namely in vitro drug release, in vitro drug permeation, drying properties, and mechanical properties, and three medium-risk CQAs, namely pH, viscosity, and film appearance were identified and investigated. Moreover, four high-risk CMAs were also considered during the formulation: permeation enhancing excipients, drying excipients, film-forming excipients, and emollients. During the experiments, LID-HCl influenced these critical parameters highly, thereby reducing the drying time. The formulation containing 25% silicone showed the best mechanical properties (49 mN skin adhesion, 20.3% film flexibility, 1.27 N film burst strength), which could predict better patient adherence. In addition, in vitro permeation studies showed that formulation containing 50% silicone has the fastest permeation rate. The flux of diffused API was 6.763 µg/cm2/h, which is much higher compared to the silicone-free formulation (1.5734 µg/cm2/h), and it can already be observed in the lower part of the dermis in 0.5 hour. Conclusion Our results show that LID-HCl has great influence on the critical parameters of FFSs. The silicone content can improve the applicability of formulations and has a favorable effect on the permeation rate of LID-HCl into the skin.