Analysis and Experiment of Cutting Mechanical Parameters for Caragana Korshinskii (C.K.) Branches

In order to investigate the cutting mechanical characteristics of Caragana Korshinskii (C.K.) branches and explore the optimal combination of cutting parameters to support the subsequent equipment development, this paper explores the relationship between branch diameter D, average cutting speed v, wedge angle β, slip cutting angle α, cutting height h, cutting gap t, moisture content M and peak cutting force by using a homemade swing-cut branch cutting test bench with peak cutting force of branches as the target value under unsupported and supported cutting methods, respectively, through single-factor tests. Based on the single-factor test, v, β, α and t were selected as the test factors, and a multi-factor test was conducted with the peak cutting force as the target. Test result: The best combination of unsupported cutting in the range of multi-factor test is v for 3.315 m·s−1, β for 20°, α for 20°, when the peak cutting force is 95.690 N. Supported cutting multi-factor test range to get the best combination of v for 3.36 m·s−1, β for 20°, α for 20°, t for 1.38 mm, when the peak cutting force is 53.082 N. The errors of the predicted peak cutting force and the measured peak cutting force of the obtained model were 1.3% and 3.9%, respectively, which prove that the cutting parameters were optimized reliably. This research can provide a theoretical basis for subsequent development the C.K. harvesting equipment.