Shaping Ability of the Conventional Nickel-Titanium and Reciprocating Nickel-Titanium File Systems: A Comparative Study Using Micro–Computed Tomography

Abstract Introduction This study used micro–computed tomographic imaging to compare the shaping ability of Mtwo (VDW, Munich, Germany), a conventional nickel-titanium file system, and Reciproc (VDW), a reciprocating file system morphologically similar to Mtwo. Methods Root canal shaping was performed on the mesiobuccal and distobuccal canals of extracted maxillary molars. In the RR group ( n = 15), Reciproc was used in a reciprocating motion (150° counterclockwise/30° clockwise, 300 rpm); in the MR group, Mtwo was used in a reciprocating motion (150° clockwise/30° counterclockwise, 300 rpm); and in the MC group, Mtwo was used in a continuous rotating motion (300 rpm). Micro–computed tomographic images taken before and after canal shaping were used to analyze canal volume change and the degree of transportation at the cervical, middle, and apical levels. The time required for canal shaping was recorded. Afterward, each file was analyzed using scanning electron microscopy. Results No statistically significant differences were found among the 3 groups in the time for canal shaping or canal volume change ( P  > .05). Transportation values of the RR and MR groups were not significantly different at any level. However, the transportation value of the MC group was significantly higher than both the RR and MR groups at the cervical and apical levels ( P Conclusions In terms of shaping ability, Mtwo used in a reciprocating motion was not significantly different from the Reciproc system.