A PCI DAQ board for MWPC detectors with high-rate 2D delay line position readout

Abstract For high rate thermal neutron (and e.g. also synchrotron radiation) detection a PCI data acquisition (DAQ) board for readout of two-dimensional position-sensitive multi-wire proportional chamber (MWPC) detectors with delay line position encoding was developed, and a first series of boards was produced and tested. The MWPC board comprises a deadtime-less 8-channel multihit TDC chip of the F1 type with ∼120 ps LSB, a 40 MHz flash ADC, a FPGA, a FIFO, a 0.9 GFLOP DSP chip TMS320C6711 and a 256 MB histogram memory. For position encoding a position-independent start and four position-dependent stop signals are recorded from the MWPC anode and from either end of X and Y delay lines connected to the MWPC cathodes, respectively. Time-of-flight (TOF) can be measured with reference to a pulsed beam or chopper signal either with ⩾25 ns bin size for TOF ranges of up to ∼420 ms or alternatively with ∼120 ps LSB for ranges ⩽16 ms . The pulse height of the MWPC anode signal is digitized in the flash ADC for neutron-gamma and background discrimination. Hardware event filtering in the FPGA allows event rates up to 1 Mevents/s by disentangling of two events occurring within the delay line time length of e.g. 250 ns . Whilst list mode data are recorded with full rate and full resolution on the host PC disk, 1D–3D histograms can be accumulated online in the on-board HM for a fraction of the data and with reduced resolution.