Co-Firing Characteristics of Cordierite Tapes with Ag/Pd for High Frequency Chip Inductors

As a new electronic material, low-temperature sintering, low-dielectric cordierite tapes exhibit great potential in the manufacturing of high frequency inductors. While the co-firing of cordierite dielectric material with conductive metal in lower sintering temperature is always a difficulty, and it directly affects the practical application of the inductors. In this paper, the prepared cordierite tapes with low-sintering temperature, low dielectric constant, and low losses were used as matrix material, and the co-firing characteristics of cordierite tapes with Ag/Pd was preliminary studied to investigate the feasibility in the manufacturing process. Deformation, pores, and delaminations are three main defects of the co-fired samples. With an Al2O3 powders and press blocks assisted process, good co-firing effect of cordierite tapes with Ag/Pd can be obtained at 900 °C. The co-firing interface of cordierite tape and Ag/Pd is very dense and no obvious element migration is detected. The paper is contributed ...