Preparation and Photocatalytic Properties of CdS/F–TiO2 Composites

2019 
F–TiO2 was prepared by a simple precipitation method using titanium sulfate as the titanium source, hydrogen fluoride as the fluorine source and ammonia as the precipitant. CdS/F–TiO2 composites were prepared by hydrothermal synthesis of CdS and F–TiO2. The surface morphology, crystal phase composition, ultraviolet absorption band, fluorescence intensity, element composition, valence state, specific surface and pore structure of the samples were characterized by using field emission scanning electron microscopy (FESEM), X-ray diffraction (XRD), ultraviolet visible absorption spectrum (UV-Vis-Abs), Molecular fluorescence spectrophotometer (PL) and X-Ray photoelectron spectroscopy (XPS) and Surface area analyzer (BET), respectively. The effects of the dosage of the photocatalyst, pH value, the concentration of methyl orange and the addition of H2O2 on the photocatalytic performance were investigated with methyl orange solution as the target degradation product. The results showed the optimum condition for photodegradation of methyl orange by 1% CdS/F–TiO2 is that the pH value, the solid-liquid ratio, the concentration of methyl orange and the dosage of H2O2 is 2, 2 g/L, 10 mg/L and 3%, respectively. Under the same conditions, the degradation rate of methyl orange by 1% CdS/F–TiO2 was 93.36% when 300 W metal halide lamp was irradiated for 20 minutes, which was significantly higher than that of F–TiO2. CdS has a significant effect on the morphology, crystallinity, grain size and the compound probability of electrons and holes after the F–TiO2 modification. The composite causes a significant red shift at the edge of the F–TiO2 light absorption band. The photocatalytic degradation of methyl orange by 1% CdS/F–TiO2 follows the Langmuir-Hinshelwood first-order kinetic model.
    • Correction
    • Source
    • Cite
    • Save
    • Machine Reading By IdeaReader
    33
    References
    2
    Citations
    NaN
    KQI
    []