Minimum number of myosin motors accounting for shortening velocity under zero load in skeletal muscle

Key points Myosin filament mechanosensing determines the efficiency of the contraction by adapting the number of switched ON motors to the load. Accordingly, the unloaded shortening velocity (V0) is already set at the end of the latency relaxation (LR), ∼10 ms after the start of stimulation, when the myosin filament is still in the OFF state. Here the number of actin-attached motors per half-myosin filament (n) during V0 shortening imposed either at the end of LR or at the plateau of the isometric contraction is estimated from the relation between half-sarcomere compliance and force during the force redevelopment after the shortening. n decreases progressively with the shortening and, during V0 shortening starting at the end of LR, is 1–4. Reduction of n is accounted for by a constant duty ratio of 0.05 and a parallel switching OFF of motors, explaining the very low rate of ATP utilization found during unloaded shortening. Abstract The maximum velocity at which a skeletal muscle can shorten (that is the velocity of sliding between the myosin filament and the actin filament under zero load, V0) is already set at the end of the latency relaxation (LR) preceding isometric force generation, ∼10 ms after the start of electrical stimulation in frog muscle fibres at 4°C. At this time Ca2+-induced activation of the actin filament is maximal, while the myosin filament is in the OFF state characterised by most of the myosin motors lying on helical tracks on the filament surface, making them unavailable for actin binding and ATP hydrolysis. Here, the number of actin-attached motors per half-thick filament during V0 shortening (n) is estimated by imposing, on tetanized single fibres from Rana esculenta (at 4°C and sarcomere length 2.15 μm), small 4 kHz oscillations and determining the relation between half-sarcomere (hs) compliance and force during the force development following V0 shortening. When V0 shortening is superimposed on the maximum isometric force T0, n decreases progressively with the increase of shortening (range 30–80 nm per hs) and, when V0 shortening is imposed at the end of LR, n can be as low as 1–4. Reduction of n is accounted for by a constant duty ratio of the myosin motor of ∼0.05 and a parallel switching OFF of the thick filament, providing an explanation for the very low rate of ATP utilization during extended V0 shortening. This article is protected by copyright. All rights reserved