Three-dimensional numerical thermal and rheological modelling in the central Fennoscandian Shield

Abstract A three-dimensional model for the central Fennoscandian Shield was constructed for analysing the thermal, the rheological and the structural conditions in the lithosphere. The mesh covers a rectangular area in the southern Finland with horizontal dimensions of 500 km × 400 km and a depth extent of 100 km. Structural boundaries are derived from the several deep seismic soundings carried out in the area. Constructed model is first used in the calculation of the thermal and the rheological models and secondly in analysing the stress and the deformational conditions with the obtained rheology. Thermal and structural models are solved with the finite element method. The calculated surface HFD is between 40 and 48 mW m −2 in the Proterozoic southern part and below 40 mW m −2 in the older and northern Archaean part of the model. The calculated rheological strength shows a layered structure with two individual rheologically weak layers in the crust and strong layer in the upper part of the lower crust. The minimum brittle–ductile transition (BDT) depth is around 10 km in the southern part of the model while in the north and north-eastern parts the BDT depth is around 45–50 km. Comparison with the focal depth data shows that as most of the earthquakes occur no deeper than the depth of 10 km are they located in the brittle regime. Resulting stress conditions and possible regions of deformation after the model is subjected to pressure of 50 MPa reveals that the stress field is quite uniformly distributed in different crustal layers and that the elastic parameters control more the state of the stress than the applied rheological structure. In the upper crust, the stress intensity has values between 42 and 45 MPa whereas in the middle crust the values are around 50 MPa. Comparison of the 3-D model with earlier 2-D models shows that some differences in the results are to be expected.