Electric current-controlled synthesis of BaTiO3

In BaTiO3, flash-sintering associated with a surge of the specimen electric current sometimes results in an inhomogeneous microstructure including Ti-excess secondary phases because of discharging. We applied field-assisted sintering technique (FAST) under precisely controlled specimen current that was set just below the threshold value for the occurrence of flash event for BaTiO3, to avoid the occurrence of the discharging. As a result, uniform and fine-grained compacts were obtained without any secondary phases. A relative density of approximately 92% was achieved under FAST condition of 100 V/cm with a limiting current of 72 mA and soaking time of 3 hours at 1070°C. The voltages during sintering under a constant current of 72 mA were found to decrease during the soaking process. Electron energy loss spectroscopy revealed the generation of excess oxygen vacancies at/near grain boundaries. The excess oxygen vacancies induced by application of DC electric fields were confirmed to reduce the voltages and to retard the shrinkage rate in a final sintering stage.