Development of silicon optics for an integrated micro-optical system-on-a-chip
2013
Development of silicon-based passive optical components such as reflectors, waveguides, and beam splitters coupled with active elements such as light emitters and detectors enable miniaturisation of a low-cost system-on-a-chip sensing device. In this work, we investigate methods to fabricate passive silicon elements on a chip. We use a combination of wet and dry etching techniques to realise angled and vertical sidewalls normal to the surface of a silicon wafer, respectively. For wet etching, we used Triton-X, a surfactant, added to an alkaline solution TMAH as the etchant. This allows perfect 45° inclined sidewalls to be fabricated. Dry etching using DRIE is to be performed on the reverse-side of the same wafer to realize through-hole vias with straight vertical sidewalls. A final Au metal layer can then be coated onto the sidewalls to realize reflective surfaces. Photolithography masks used in the wet and dry etch processes were designed and fabricated. By careful alignment of these masks using a mask aligner, we can fabricate a combination of inclined and vertical sidewalls to build optical reflectors and beam splitters with complex geometries. When integrated with active Si-optical devices, a fully integrated micro-optical system-on-a-chip can be realised.
Keywords:
- Correction
- Source
- Cite
- Save
- Machine Reading By IdeaReader
4
References
0
Citations
NaN
KQI