LEAP-UCD-2017 Centrifuge Test Simulation at UNINA

Within the framework of the LEAP-UCD-2017 exercise, Type B simulations of centrifuge tests were conducted assuming a hypoplastic constitutive model for sand. Differently from the most common elastoplastic approach, the hypoplasticity does not decompose the strain rate into elastic and plastic parts and does not use explicitly the notions of the yield surface and plastic potential surface. The process followed to calibrate the constitutive model is presented in detail. The initial state of stresses in the analyzed mesh, the key parameters used in the dynamic simulation phase, and a comparison of the simulation with some experimental results are reported. All the simulations were performed using the model parameters calibrated by using the laboratory test data. Finally, a sensitivity analysis of computed displacement to soil density and ground motion intensity show the influence of such factors on the seismic soil response of liquefiable soils.