Light interception and radiation use efficiency in temperate quinoa (Chenopodium quinoa Willd.) cultivars

Abstract Sea level quinoas are grown at low altitudes in Central and Southern Chile. Both sensitivity to photoperiod and response to temperature largely determine quinoa adaptation, but crop biomass production must be quantified to evaluate agronomic performance. The objectives of this work are: (i) to characterize development effects on leaf area evolution for genotypes of sea level quinoa differing in cycle length, (ii) to quantify the extinction coefficient ( k ) for photosynthetically active radiation (PAR) and radiation use efficiency (RUE) from emergence up to the beginning of grain filling and (iii) to identify which crop attributes related to canopy architecture should be considered to improve biomass production. Four cultivars (NL-6, RU-5, CO-407 and Faro) were cropped in Pergamino (33°56′S, 60°35′W, 65 m a.s.l.), Argentina, at three densities (from 22 to 66 plants m −2 ) in two consecutive years under field conditions with adequate water and nutrient supply. Thermal time to first anthesis and maximum leaf number on the main stem were linearly correlated ( r 2  = 0.87; p p −2 . Values for RUE changed as cumulative intercepted PAR (IPAR) increased; at initial stages of development RUE was 1.25 ± 0.09 g MJ IPAR −1 , but if cumulative IPAR was higher than 107.5 ± 10.4 MJ IPAR m −2 , RUE was 2.68 ± 0.15 g MJ IPAR −1 . That change occurred when leaf area index (LAI) and fraction of PAR intercepted were still low and ranged from 0.61 to 1.38 and from 0.33 to 0.51, respectively. No significant association was found with any developmental stage. Our results agreed to the notion that RUE variation during pre-anthesis phases is largely determined by LAI through its effect on radiation distribution within the canopy. Biomass production could be improved if periods of interception below 50% of incoming PAR were reduced to ensure high RUE. This seems to be possible in temperate areas both by the use of late genotypes with a higher number of leaves on the main stem and by early genotypes provided adequate plant density is chosen. Early increment in LAI and overlapping of the leaf area increase period with the flowering phase are desirable strategies for earliest genotypes to maximize yield.