Improvement in the long-term stability of an amperometric glucose sensor system by introducing a cellulose membrane of bacterial origin.

Classical amperometric glucose sensors that use cellulose membranes of wood origin (Cuprophan) suffer from the fact that their long-term stabilipy in blood is short; therefore, their clinical use is limited. In the present study, a classical amperometric glucose sensor was covered with a bacterial cellulose (BC) membrane. Its surface in comparison to that of the classical glucose sensor (Cuprophan) and its long-term stabilipy were tested in vitro and in vivo. The surface element composition was ∼44% oxygen and ∼56% carbon in both membranes and thus typical for cellulose. BC membranes exhibited fiber structure, whereas cup membranes did not. There was also a qualitative difference in protein adsorption between both membranes on exposure to bovine serum albumin. Treatment with Trogamid of one site of the BC membranes allowed linear glucose detection between 0 and 40 mM. Hemocompatibility of BC membranes was improved in comparison to cup membranes on the basis of complement activation (C3a and C5a). In diluted blood (1:10), the BC-covered sensor exhibited a long-term stability of more than 200 h; in undiluted blood it was stable for about 24 h, which is about 6-7 times lower than the stability of the classical Cup membrane-covered sensor. In in vivo studies, where the BC membrane-covered sensors were connected to the jugular vein of rats, blood glucose levels could be monitored for at least 24 h. In summary, the use of a modified bacterial cellulose membrane to cover the classical amperometric glucose sensor significantly improves the sensors long-term stability both in vitro and in vivo