Optimum Pore Size for Bone Cement Fixation

: The interface shear properties of porous coated Ti-6Al-4V alloy embedded in bone cement were examined as a function of pore size. Cylindric Ti-6Al-4V alloy push-out specimens were coated with two layers of spheric powders having particle size ranges of 297-420 microns, 420-500 microns, 595-707 microns, and 850-1400 microns. Sintering resulted in mean pore sizes of 165, 285, 345, and 550 microns, respectively, and porosities in the range of 40%-44%. There was a statistically significant difference between the mean pore sizes obtained from the four particle size ranges. There were no differences between the mean porosities. The porous-coated specimens were embedded in bone cement and mechanical push-out testing was performed. Non-coated specimens having a satin surface finish were also embedded in bone cement and tested. The noncoated metal specimens displayed an interface shear strength of 4.2 +/- 0.4 MPa, whereas the shear strengths for the porous-coated specimens were significantly higher and increased as pore size increased. The mean interface shear strengths determined were 17.0 +/- 2.1 MPa (165 microns pore size), 18.1 +/- 2.3 MPa (285 micron pore size), 23.6 +/- 1.7 MPa (345 microns pore size), and 25.4 +/- 3.4 MPa (550 microns pore size). Significant differences in shear strength for the porous-coated specimens were found between the two smaller particle sizes and the two larger particle sizes. As pore size increased from 285 microns to 345 microns, a statistically significant increase in shear strength from 18.1 MPa to 23.6 MPa was observed.