Preparation of electrospun nanofibers with desired microstructures using a programmed three-dimensional (3D) nanofiber collector

Abstract The traditional electrospinning process produces dense two-dimensional (2D) nanofiber (NF) sheets that limit cell infiltration and proliferation. Our previous study demonstrated that 3D NF sheets could be formed on an NF collector surface mounted with multiple movable needles through the corona discharge. In this study, we developed a programmed electrospun 3D NF collector. It can precisely control the moving speed of NF collector during electrospinning; thereby fabricating 3D NFs with desired microstructures (pore size, pore volume, and interconnectivity). Four types of polycaprolactone (PCL) 3D NF matrices with different microstructures can be obtained concurrently on the NF collector surface, which are set by different forward moving speed of the NF collector device: NF-zero (no move, as control), NF-low (0.085 mm/min), NF-mid (0.158 mm/min) and NF-high (0.232 mm/min). A linear increase of the NF sheet thickness (from 0.21 mm to 0.91 mm) was recorded with accelerating collector movement. Quantitative analysis using scanning electron microscopy (SEM), micro-computed tomography (μ-CT), and confocal laser scanning microscopy (CLSM) showed a monotonic increase of pore size and porosity with the increase of collector moving speeds. The collector movement also impacted the crystallinity and mechanical properties of the NFs. When prepared at high collector speed, the NFs showed improved proliferation and differentiation (p