Membrane fouling in a hybrid process of enhanced coagulation at high coagulant dosage and cross-flow ultrafiltration for deinking wastewater tertiary treatment

Abstract A hybrid process of enhanced coagulation at a high dosage of polyaluminum chloride and flat-sheet cross-flow ultrafiltration was used for the advanced treatment of the effluent from a biological treatment process of deinking wastewater in a paper mill. The experimental results obtained by a small-scale continuous laboratory experimental device showed that the absorption resistance was significantly lower than the membrane intrinsic resistance, the concentration polarization resistance, the pore blocking resistance, and the cake layer resistance and so it can be ignored. With increasing polyaluminum chloride dosage from 0 to 2,000 mgL -1 , the total membrane filtration resistance decreased and the membrane flux increased, but the concentration polarization resistance increased. With the increase in cross flow velocity, the total membrane filtration resistance, the pore blocking resistance, the layer resistance, and the concentration polarization resistance all decreased, and consequently, the membrane flux increased. With regard to the concentration polarization resistance, the cross flow velocity had a more significant effect than the trans-membrane pressure. But the trans-membrane pressure had a more significant effect on the layer resistance, the pore blocking resistance, and the total membrane filtration resistance than the cross flow velocity. The filtration resistance at the polyaluminium chloride dosage of -1 could be ranked as follows: the membrane intrinsic resistance > the pore blocking resistance > the layer resistance > the concentration polarization resistance> the absorption resistance. But it was the membrane intrinsic resistance > the concentration polarization resistance > the pore blocking resistance > the layer resistance > the absorption resistance at the dosage of ≥1,000 mgL -1 . The results are helpful for the membrane fouling control and can promote the application of flat-sheet cross-flow membrane process, resultantly improving the reclaim and reuse of deinking wastewater, and reducing the emission of contaminants in deinking wastewater.