CO2-Tolerant Oxygen Permeation Membranes Containing Transition Metals as Sintering Aids with High Oxygen Permeability

Chemical doping of ceramic oxides may provide a possible route for realizing high-efficient oxygen transport membranes. Herein, we present a study of the previously unreported dual-phase mixed-conducting oxygen-permeable membranes with the compositions of 60 wt.% Ce0.85Pr0.1M0.05O2-δ-40 wt.%Pr0.6Sr0.4Fe0.8Al0.2O3-δ (M = Fe, Co, Ni, Cu) (CPM-PSFA) adding sintering aids, which is expected to not only improve the electronic conductivity of fluorite phase, but also reduce the sintering temperature and improve the sintering properties of the membranes. X-ray powder diffraction (XRD) results indicate that the CPM-PSFA contain only the fluorite and perovskite two phases, implying that they are successfully prepared with a modified Pechini method. Backscattered scanning electron microscopy (BSEM) results further confirm that two phases are evenly distributed, and the membranes are very dense after sintering at 1275 °C for 5 h, which is much lower than that (1450 °C, 5 h) of the composite 60 wt.%Ce0.9Pr0.1O2-δ-40 wt.%Pr0.6Sr0.4Fe0.8Al0.2O3-δ (CP-PSFA) without sintering aids. The results of oxygen permeability test demonstrate that the oxygen permeation flux through the CPCu-PSFA and CPCo-PSFA is higher than that of undoped CP-PSFA and can maintain stable oxygen permeability for a long time under pure CO2 operation condition. Our results imply that these composite membranes with high oxygen permeability and stability provide potential candidates for the application in oxygen separation, solid oxide fuel cell (SOFC), and oxy-fuel combustion based on carbon dioxide capture.