Comparative Study of Optimization Models for Evaluation of EDM Process Parameters on Ti-6Al-4V

In this paper, different optimization techniques such as multi-objective optimization based on ratio analysis, the -nD angle, information divergence and multi-angle optimization methods were considered for comparative study in order to check their variation in results. These four techniques were considered asthese techniques were made from completely different methodologies, such as MOORA, is one of the latest multi-criteria decision-making methods that cover the weakness of other older methods and the latter three (-nD angle, Information Divergence and MAOT) methods are based on trigonometric methodologies. These optimization techniques were carried out using the effect of EDM process parameters viz., material removal rate and surface roughness as output parameters and current, pulse on time, pulse off time and different electrode materials as input process parameters. These parameters were obtained from the experiments modelled according to the Taguchi experimental design procedure in which the L18 orthogonal array was used to perform experimentation with the material of titanium alloy (Ti-6Al-4V). All the optimization techniques have obtained similar results among which -nD angle and Information Divergence technique tend to be easier and understandable for any similar application. The latter two methods avoid complexity and can be used for optimizing any relevant manufacturing process parameters such as the parameters of EDM, additive manufacturing, etc.