Numerical study of thermal control system for rapid heat cycle injection molding process

This paper studies heat transfer during rapid heat cycle injection molding process. Actually, the mold is heated and cooled with channels in which steam or water circulates. The purpose of this numerical study is to improve the design of heating/cooling system to ameliorate the quality of the polymer part and the cycle productivity. Transfers in mold, translating thermal phenomena are predicted by the finite volume method and the fractional area volume obstacle representation in cyclic transient regime. It was found that the steady cycle is obtained rapidly (after two or three cycles) for the rapid heat cycle molding process when compared to conventional injection molding. The mathematical modeling was developed to explore the effect of control temperature system characteristics on temperature uniformity of the cavity surface and thermal response efficiency. The three-dimensional simulation results show the limitations of the conventional system when compared to the conformal configuration. This research ...