Avoiding abnormal grain growth in thick 7XXX aluminium alloy friction stir welds during T6 post heat treatments

Abstract Friction stir welding (FSW) is becoming an essential welding technique in the aerospace industry. However, friction stir welds are usually weaker than the parent material. The dissipated heat causes a softening of the 7XXX series aluminium alloys. Post-welding heat treatments are used to restore the highest strength after welding. The reference treatment is composed of two-steps heating: a solution heat treatment typically at 470°C for 30 minutes, quench in water followed by artificial aging 120°C for 24 hours. These treatments are responsible for very significant grain coarsening in the weld nugget zone known as secondary recrystallization, sometimes leading to abnormal grain growth (AGG). This is particularly true for thick plates. This secondary recrystallization phenomenon is detrimental for tensile performances. A detailed analysis of the conditions leading to secondary recrystallization during post-welding heat treatments is provided. A procedure to avoid secondary recrystallization in FSWed joints is then highlighted. Thermal cycles during welding are controlled by welding on a low thermal conductivity backing plate (i.e. stainless steel) which avoids very fine grains in the bottom of the weld nugget. This new procedure opens the path to excellent welds presenting at least the strength and ductility of the T6 base material.