Laser deposition additive manufacturing of 17-4PH stainless steel on Ti-6Al-4V using V interlayer
2019
For the first time, additive manufacturing was used to obtain a strong joint (bonding strength >200 MPa) between stainless steel and Ti-6Al-4V using a V interlayer. The V interlayer applied via solid-state joining prevented the formation of brittle intermetallic phases more effectively than a V interlayer deposited by a liquid-state process. The microstructure and strength of the joint interface depended on the laser power and scan speed. The joint strength decreased with increasing annealing time, especially after 4 and 24 h, demonstrating the presence of the Fe-V-Cr σ-phase.
Keywords:
- Correction
- Source
- Cite
- Save
- Machine Reading By IdeaReader
19
References
9
Citations
NaN
KQI