Transient modeling of viscosity

Capillary and parallel plate rheological characterization was conducted for a low-density polyethylene. In contrast with conventional rheological analysis, steady conditions were not assumed. Transient data, with time steps between 0.0001 and 0.2 s, were analyzed with a nonlinear, viscoelastic constitutive model in which the relaxation time was modeled as a function of the applied stress. The fit model explained more than 99% of the observed transient variation in the capillary and parallel plate rheometers. The model coefficients for the capillary and parallel plate were compared directly to conventional linear viscoelastic analysis of the same parallel plate data. The results indicate that the described constitutive model closely predicts the observed viscoelastic behavior of the polymer melt tested in the parallel plate rheometer. Furthermore, the results indicate that the relaxation spectrum modeled with the transient analysis of the capillary rheological data correlate closely to the results predicted by the same transient analysis of parallel plate rheological data. The conclusion is that described constitutive modeling describes the viscoelastic behavior in both capillary and parallel plate rheometers. Moreover, the analysis and results suggest that the viscoelastic behavior of the polymer melt is a significant factor during the rheological characterization and the modeling of the transient response should be taken into consideration during rheological analysis to provide high fidelity models. POLYM. ENG. SCI., 2017. © 2017 Society of Plastics Engineers