FAULT DIAGNOSIS OF A HIGH VOLTAGE TRANSMISSION LINE USING WAVEFORM MATCHING APPROACH

This paper is based on the problem of accurate fault diagnosis by incorporating a waveform matching technique. Fault isolation and detection of a double circuit high voltage power transmission line is of immense importance from point of view of Energy Management services. Power System Fault types namely single line to ground faults, line to line faults, double line to ground faults etc. are responsible for transients in current and voltage waveforms in Power Systems. Waveform matching deals with the approximate superimposition of such waveforms in discretized versions obtained from recording devices and Software respectively. The analogy derived from these waveforms is obtained as an error function of voltage and current, from the considered metering devices. This assists in modelling the fault identification as an optimization problem of minimizing the error between these sets of waveforms. In other words, it utilizes the benefit of software discrepancies between these two waveforms. Analysis has been done using the Bare Bones Particle Swarm Optimizer on an IEEE 2 bus, 6 bus and 14 bus system. The performance of the algorithm has been compared with an analogous meta-heuristic algorithm called BAT optimization on a 2 bus level. The primary focus of this paper is to demonstrate the efficiency of such methods and state the common peculiarities in measurements, and the possible remedies for such distortions.