Microtensile bond strength to sealer-contaminated dentin after using different cleaning protocols

Abstract Background/purpose Sealer residues on dentin may affect bonding to restorative materials. This study aimed to evaluate the bond strength to sealer-contaminated dentin after using different cleaning protocols. Materials and methods Freshly extracted bovine incisors were prepared and exposed the buccal pulp chamber dentin, obtaining segments measuring 5 mm × 5 mm with a height of 3 mm. The segments were randomly distributed into 4 groups (n = 7) according to different protocols. Control group: no contamination was performed. In the three experimental groups, the segments were contaminated with epoxy resin-based sealer for 5 min, and different cleaning protocols were performed. Acetone group: acetone-saturated cotton pellets were used to wipe the sealer. Ultrasound group: ultrasonic ET-20D tip cleaning. Acetone combined with ultrasound group: cleaning with acetone-saturated cotton pellets and ultrasonic tip. All segments were bonded using a self-etch adhesive. Two samples in each group were scanned by swept-source optical coherence tomography (SS-OCT) to evaluate sealer residues. A microtensile test was performed on the remaining 5 samples, which were built up with composite resin. Results Sealer residues were observed in 3 of 14 (21.4%) sections of acetone group by SS-OCT. Compared to the control, ultrasound alone or in combination with acetone preserved the bond strength (P > .05). The ultrasound group exhibited the highest bond strength (39.38 MPa), which differed from that of the acetone group, which provided the lowest bond strength (32.88 MPa) (P  Conclusion Cleaning epoxy resin-based sealer-contaminated dentin surfaces using ultrasound or combined with acetone could preserve the bond strength.