Self-dressing effect using a fixed abrasive platen for single-sided lapping of sapphire substrate

Single-sided lapping is crucial in sapphire wafering processes for improving flatness and achieving the target wafer thickness using loose abrasives. In single-sided lapping process, the Material removal rate (MRR) is a key factor for reducing process time and cost. However, the MRR is limited when using loose abrasives because abrasives mostly act by rolling and sliding. Many researchers have studied fixed abrasives to increase the MRR, but the MRR decreases with time. To solve this problem, the self-dressing effect was studied with various pressures, velocities, cutting fluids and wafers. The MRR decreased due to the wear of abrasives, and the pressure and velocity have little effect on the self-dressing. Lapping experiments were done using cutting fluid with a lapped wafer and sawed wafer. The MRR, plate roughness and thickness were measured to study the wear of the abrasive and the self-dressing effect. The cutting fluid delayed the wear of the abrasives and thus improved the decrease in MRR, but it had little effect on the self-dressing effect, like in the case when water was used. When using cutting fluid and a sawed wafer, the MRR was high and did not decrease. A concentrated load on the plate caused by shape error and saw marks on the sawed wafer could produce the self-dressing effect. We verified that a sawed wafer could produce the self-dressing effect on even a worn plate.