Preparation of zirconia mullite flakes via a plasma rapid solidification process using starting materials derived from a sol-gel technique

Abstract Flakes of zirconia–mullite with different zirconia contents varying from 3 to 24 wt% were produced from sol–gel derived raw materials via a plasma melting method followed by a rapid solidification process using a rotating copper roll. The morphology, phase constitution and microstructure development of the as-prepared flakes and of the flakes after various heat treatments were investigated by means of X-ray diffraction (XRD), scanning electron microscopy (SEM), transmission electron microscopy (TEM) and energy dispersive spectroscopy (EDS). It was found that the starting materials could be transformed from the initial irregular-shaped powders into flakes which consisted of mullite, zirconia phase, a relatively large amount of glassy phase and pores. Using TEM, it was shown that the crystalline phases consisted of zirconia polymorphs and mullite. The glassy phases consisted of Al 2 O 3 –SiO 2 solid solution supersaturated with zirconia. Firing at 1500 °C or 1700 °C resulted in full crystallisation of the flakes and a fairly homogeneous distribution of zirconia particles in terms of size and shape dispersed in the mullite matrix, which contained both intra-granular and inter-granular precipitates. The microstructural characteristics of the flakes may provide promising physical properties for applications in high temperature thermal insulation materials.