H2S removal from syngas using wastes pyrolysis chars

Abstract Pyrolysis chars from wastes were investigated as sorbents for H 2 S removal from syngas. The H 2 S removal tests were performed at ambient temperature in various dry gas matrices (N 2 , Air, Syngas) to study the effect of the gas composition on the adsorption efficiency. Two chars were produced by the pyrolysis of: used wood pallets (UWP), and a 50/50% mixture of food waste (FW) and coagulation-flocculation sludge (CFS). The chars were functionalized by low-cost processes without chemicals: gas phase oxygenation and steam activation. Activated chars were the most efficient materials due to their large specific surface area, alkaline pH, basic O-containing groups and structural defects in graphene-like sheets. Raman analysis evidenced that inherent mineral species (especially Ca and Fe) increased the H 2 S removal efficiency by promoting the formation of metal sulfide and metal sulphate species at the char surface. Mesopores lower than 70 A were revealed to be important adsorption sites. Under dry Syngas matrix, the chars remained efficient and selective toward H 2 S removal despite the presence of CO 2 , while O 2 in the Air matrix decreased their removal capacity due to the formation of sulfur acid species. The most efficient material was the steam activated char from FW/CFS, with a removal capacity of 65 mg H2S .g −1 under dry syngas. This char was proved to be completely regenerated with a thermal treatment under N 2 at 750 °C. This study demonstrated that activated chars from food waste and sludge could be used as eco-friendly, affordable, and selective materials for syngas desulfurization even under dry atmosphere.