Development and use of quality control program in magnetic resonance

In 1992, two identical 0.5 Magnetic Resonance units were installed in Policlinico S. Orsola-Malpighi in Bologna. A Quality Assurance (QA) protocol was designed by the Medical Physics Department to monitor both systems as of Acceptance Test. Our main goals in drawing up the QA protocol were: 1) Completeness--to check all the most significant physical parameters; 2) Efficiency--to reduce examination time of the QC Protocol; 3) Reliability--to achieve good repeatability of results. The QA protocol consists of two QC programs: 1) Daily check of Variable Echo image SNR of a homogeneous phantom, Eddy Current compensation, laser printer test; 2) Monthly check of SNR of Spin Echo and Fast Scan images, integral uniformity, B0 uniformity, B1 uniformity, T2 stability, ghosts, slice thickness, slice profile, geometrical distortion, resolution power. SNR dependence on FOV, NEX, matrix and slice thickness, and resolution dependence on slice thickness and position were tested as Acceptance test. The daily checks provide continual monitoring of the performance of both systems and laser printer and have shown: 1) strong fluctuations in image reproduction probably due to film emulsion instability; 2) a "warning" of imminent malfunction. The monthly checks were in line with acceptance test data and have shown: 1) different behavior of the two systems that should perform analogously; 2) greater result stability in one system with better results also in terms of diagnostic images. The main aim of our QA protocol is to optimize diagnostic accuracy by checking several physical parameters that act as good "indicators" for possible malfunctioning. We believe this can be done with simple but useful daily QC supporting a routine more complex QC program and can be achieved through continual application of both protocols.