Segregation of chain ends to polymer melt surfaces and interfaces

The conformation of polymer chains in the melt near an impenetrable boundary has recently been studied by molecular dynamics and off-lattice Monte Carlo simulations. Both types of calculations show an enhancement of the chain end density within a distance of approximately two polymer segment lengths of the interface relative to the bulk. In the absence of preferential interactions between monomers and the interface, the segregation arises from minimizing the loss of conformational entropy near an impenetrable boundary; i.e., by positioning an end near the surface, only one unit rather than two is reflected. In order to obtain an experimental measure of this effect, monodisperse polystyrene (PS) chains of molecular weight 63 000 with short blocks of deuterated polystyrene (dPS) at each end were prepared. The block length was kept as short as possible, while yet producing sufficient neutron scattering contrast in order to minimize any preferential surface segregation due to isotopic effects. The synthesis was carried out via living anionic polymerization of a purified styrene monomer in cyclohexane at 60 C, utilizing sec-butyllithium as the initiator. The process was terminated using degassed methanol.