New approach to study the heat transfer in internal combustion engines by 3D modelling
2019
Abstract The stringent environmental constraints have led the industry to look for new technologies that improve the design of internal combustion engines (ICE), mainly focused on achieving higher thermal efficiency and reducing pollutant emissions. Numerical simulations play a key role for optimizing engine design, but modelling the physical processes such as the combustion and the heat transfer to the walls, represents a challenge due to the complexity of the phenomena involved. Combustion has to be modeled properly, and heat transfer models from gas to wall require coupling with solid wall models (CHT Conjugate Heat Transfer calculations). In this paper, a new approach is presented, focused on optimizing the computing time needed to perform CHT simulations. It is based on the use of the Rate of Heat Release (RoHR) obtained from a CFD calculation to replace the combustion process. The study is performed for a spark ignition (SI) engine. The proposed approach is validated for the heat transfer to the piston wall. The study shows that the CHT-RoHR approach yields very good results in terms of spatially averaged values during the whole engine cycle and allows considerable reduction in computational cost. It is therefore very useful to perform parametric studies.
Keywords:
- Correction
- Source
- Cite
- Save
- Machine Reading By IdeaReader
24
References
13
Citations
NaN
KQI