Improvements in Ranchero magnetic flux compression generators
2015
Los Alamos “Ranchero” Magnetic Flux Compression Generators (FCGs) have been used to power imploding liner loads. The fundamental FCG design is based on a cylindrical detonation system that expands the armature simultaneously into a coaxial generator volume and has been shown to generate currents as high as 76 MA. Analysis of the 76 MA test results revealed a weakness in the design at the output glide plane. To prevent premature shorting at the output current slot of the generator, the armature/glide plane interface was originally designed to lag the leading edge of the armature. However, 2D-MHD calculations reveal that at very high currents a magnetically driven aneurism develops in this lagging section which reduces the performance of the generator. A new model Ranchero is being developed to correct this weakness and provide enhanced performance. In the new model, the output glide plane is eliminated and the armature is extended along the FCG axis, with its radius increasing along a curve until it reaches the current output slot. A cylindrical detonation system of the type required for earlier designs continues to be used, and the high explosive (HE) in the extended section is detonated by the last point of the cylindrical detonator. The stator of the FCG is contoured, allowing the contact point of the armature to zipper from the input to the output end in the last few μs of flux compression. In addition, the new model Ranchero is intended to use PBX 9501 (9501) for the HE and also remove the smoothing layer, which has been part of all Ranchero HE systems to date. Both of these factors lead to increased performance. 9501 is more energetic than the PBXN 110 used in Ranchero generators to date, and both calculations and experiments have shown that the smoothing layer is not needed when the detonator point spacing is 18 mm. Tests of original model Rancheros using PBXN 110 castable HE, with an imbedded smoothing layer, demonstrated an armature expansion velocity of 3.1 mm/μs. Further tests show that removal of the smoothing layer increases the speed to 3.3 mm/μs, and replacement of the cast PBXN 110 with 9501 without a smoother gives a velocity of 3.8 mm/μs. Designs, concerns, and experimental results facilitating the new model Ranchero are presented. In addition, performance estimates are given for the initial imploding liner tests to be conducted, and further computational details are presented in a companion paper given by C. L. Rousculp and others at this conference.
Keywords:
- Correction
- Source
- Cite
- Save
- Machine Reading By IdeaReader
0
References
0
Citations
NaN
KQI