Mechanical characterization of 3D printed, non-planar lattice structures under quasi-static cyclic loading

While additive manufacturing via melt-extrusion of plastics has been around for more than several decades, its application to complex geometries has been hampered by the discretization of parts into planar layers. This requires wasted support material and introduces anisotropic weaknesses due to poor layer-to-layer adhesion. Curved-layer manufacturing has been gaining attention recently, with increasing potential to fabricate complex, low-weight structures, such as mechanical metamaterials. This paper aims to study the fabrication and mechanical characterization of non-planar lattice structures under cyclic loading.,A mathematical approach to parametrize lattices onto Bezier surfaces is validated and applied here to fabricate non-planar lattice samples via curved-layer fused deposition modeling. The lattice chirality, amplitude and unit cell size were varied, and the properties of the samples under cyclic-loading were studied experimentally.,Overall, lattices with higher auxeticity showed less energy dissipation, attributed to their bending-deformation mechanism. Additionally, bistability was eliminated with increasing auxeticity, reinforcing the conclusion of bending-dominated behavior. The analysis presented here demonstrates that mechanical metamaterial lattices such as auxetics can be explored experimentally for complex geometries where traditional methods of comparing simple geometry to end-use designs are not applicable.,The mechanics of non-planar lattice structures fabricated using curved-layer additive manufacturing have not been studied thoroughly. Furthermore, traditional approaches do not apply due to parameterization deformations, requiring novel approaches to their study. Here the properties of such structures under cyclic-loading are studied experimentally for the first time. Applications for this type of structures can be found in areas like biomedical scaffolds and stents, sandwich-panel packaging, aerospace structures and architecture of lattice domes.,This work presents an experimental approach to study the mechanical properties of non-planar lattice structures via quasi-static cyclic loading, comparing variations across several lattice patterns including auxetic sinusoids, disrupted sinusoids and their equivalent-density quadratic patterns.