Optimization of two-step catalyzed biodiesel production from soybean waste cooking oil

An acid–base-catalyst-based two-step biodiesel production experiment from soybean waste cooking oil was carried out to identify which parameter is the most influential among the experimental parameters by using the Taguchi method. Heterogeneous catalysts were used to avoid a water-consuming homogeneous catalyst removal process. Ferric sulfate and calcium oxide were used as acid and base catalysts, respectively, for the heterogeneous reaction. Reaction time and methanol-to-triglyceride mole ratio were significant factors. The optimum parameters for step 1 (acid esterification) were 4 h of reaction time, 4 wt. % of ferric sulfate amount, a 16:1 methanol to triglyceride mole ratio, and 400 rpm of mixing speed, respectively. For the transesterification step, the most influential factor was reaction time, and CaO amount was significant as well. On the other hand, the mole ratio of methanol and oil was relatively less significant. Optimum parameters were 3 h of reaction time, 2 wt. % of CaO, and a 12:1 methanol to triglyceride mole ratio with mixing speed at 400 rpm in this experimental range. Under the optimum conditions, waste cooking oil with 5.27 mg KOH/g of acid value was converted into crude biodiesel by a two-step process with fatty acid methyl ester content reaching 89.8 % without any further post-purification.