Experimental Research on the Process Parameters of a Novel Low-Load Drill Bit Used for 7000 m Bedrock Sampling Base on Manned Submersible

Due to the need for accurate exploration of deep-sea scientific research, drilling techniques by combining the operational advantages of the Jiaolong manned submersible is considered one of the most feasible methods for deep-sea bedrock drilling. Based on deep sea bedrock cutting model and discrete element simulation, as well as efficient drilling as the design criterion, the development of a deep sea 7000 m electromechanical coring apparatus was carried out. The outstanding feature of this technology is that the bit load produced by the drill pressure is usually within the range 100–400 N while the recommended load for diamond drilling is 1–3 KN or even more. Therefore, searching for the drilling bits that can drill in extremely hard formations with minimal load and acceptable rates of penetration and rotary speed is the necessary step to prove the feasibility of electromechanical deep-sea drilling technology. A test has been designed and constructed to examine three types of drill bits. The results of experiments show that the new low-load polycrystalline diamond compact (PDC) bit has the highest penetration length of 138 mm/15 min under a 300 N load and 250 rpm rotary speed. Finally, field tests with the Jiaolong submersible were used to conduct deep sea experiments and verify the load model, which provides theoretical and technical data on the use of a low-load core sampling drill developed specifically for a deep sea submersible.