Influence of surface condition on deuterium release from Li2TiO3 pebble

Abstract Lithium titanate (Li 2 TiO 3 ) pebbles were irradiated with D 3 + ions with energy of 5.0 keV, and the amounts of retained deuterium in the pebbles were measured by thermal desorption spectroscopy. In this research the irradiation/heating cycles were carried out repeatedly in order to investigate the influence of surface condition on deuterium release from Li 2 TiO 3 . The composition ratio of Li decreased with the increase of the number of the irradiation/heating cycle. Then, the desorption peaks of the gases contained deuterium atoms were shifted to higher temperature region, and the amount of desorbed gases in forms of water tended to increase. In addition, we carried out other experiments for the comparison. Comparing these results, we considered that the increase of the defects created by the irradiation was more responsible for the change in the desorption behavior by the irradiation/heating cycles than the lithium depletion. These results suggest that the tritium recovery efficiency would decrease with the increase of the defects and the damages especially at the low temperature region during the operation.