Comparison Between the Numerical and Experimental Deposition Patterns for an Electrostatic Rotary Bell Sprayer

In this paper, a full 3D numerical model using ANSYS commercial software has been created to simulate the particle deposition profile for stationary and moving flat targets, assuming multiple injections of charged poly-dispersed particles. Different injection angles along three virtual rings were assumed to form a shower injection pattern. The experimental and the numerical results of deposition thickness have been presented and compared for different injection patterns. It has been found that there are some parameters, such as the total number of injection points, the radii of the rings and the fractional mass flow rate in each injection ring, which affect the numerical results of the deposition thickness and uniformity.Copyright © 2015 by ASME and General Motors