부재료가 돈분뇨 퇴비화에 미치는 영향

This paper presents an experiment to examine the possibility of treating carcass while making compost with a horizontal cylinder composting equipment. The findings were as follows: as for heavy metal content, zinc content was above the allowed level in some measuring sections of the general operation and the entire measuring sections of the carcass operation, whose copper content was higher than the general operation. The wood chip operation was lower than the allowed level in all the heavy metals and similar or the same as the carcass operation in copper, cadmium and arsenic. Its nickel content was 29.5~63.8%, which was relatively higher than 9.3~18.0% and 15.8~18.0% of the general and carcass operation, respectively. Its chrome content was 14.2~31.9%, which was relatively higher than that of the general and carcass operation. The integrated operation was lower than the allowed level in all the heavy metals. Its copper and zinc content was 34.9~54.5% and 53.1~75.9%, which was similar to 48.9~52.6% and 64.6~85.9%, respectively, in the wood chip operation. Its chrome and nickel content was stabilized while their content was rather high in the wood chip operation. The average and final moisture content of the carcass operation was 60.7% and 49.6%, respectively. Its average moisture content was a little bit higher than the recommended level of 55.0%, but its final moisture content was lower than the recommended level. The average and final moisture content of the integrated operation was 29.2% and 18.6%, respectively, which was the lowest level among the four operation modes. The overall moisture content of the operation modes was under the recommended level of 55.0% with some variance among the modes. The C/N ratio was the lowest in the carcass operation and the highest in the general operation. The average C/N ratio of the operation modes was in the range of 13.7~20.3 with the total average of 18.3, and the modes kept it under the proper level of 30.0.