Primary sources and accumulation rates of inorganic anions and dissolved metals in a MEA absorbent during PCC at a brown coal-fired power station

Abstract Post-combustion capture (PCC) of CO 2 from fossil fuel-fired power station flue gas is one of many technologies that are being developed to reduce anthropogenic greenhouse gas emissions in the medium term. Wet-gas scrubbing using aqueous amines is currently the most mature PCC technology suitable for separating CO 2 from coal-fired power station flue gases. In this study, a series of twelve samples of a degraded 30% (w/w) MEA absorbent were obtained over a six month pilot scale PCC campaign at a brown coal-fired power station in Australia. These samples were used to investigate the accumulation of heat-stable salts, inorganics and minerals. The heat-stable salts concentration increased from 0.80 to 2.29% (w/w, as MEA) and organic acids from the oxidative degradation of MEA were the largest component of heat-stable salts. Acid gases such as SO x and NO x , make-up water, ultra-fine fly-ash and corrosion were all sources of the minerals and inorganics that accumulated in the aqueous MEA absorbent. Corrosion was the single biggest contributor of transition metals and the abrupt change in ratios of Fe, Cr and Mo suggests that the dominant corrosion mechanism may have changed towards the end of the campaign. The rapid accumulation of minerals and inorganics during this PCC campaign highlights the importance of continuing research into the interactions between amine absorbents and inorganic or mineral contaminants. The data presented in this study are an important resource for design of laboratory scale experiments to investigate these physical and chemical interactions between aqueous amines, minerals and inorganics.