Microstructure Study of the Stainless Steel Layer on AlSi Cast Alloy Prepared by Laser Deposition
2019
The main aim of this study is structural changes on the layer of Al-Si cast alloy by laser austenitic stainless steel 17 246 deposition. In order to remelt the Al-Si alloy surface the laser of 1, 9 kW has been used for facing area, and 1.6 kW for the edge. The linear laser scan rate of the beam was set 450 mm.min-1 for facing area, and for the edge 550 mm.min-1. We observed that the thin surface made of austenitic stainless steel had a lot of splits. The purpose of this study is also to enhance inherent properties of the surface materials to create new product or improve on existing one.
- Correction
- Source
- Cite
- Save
- Machine Reading By IdeaReader
8
References
0
Citations
NaN
KQI