Alignment robustness for 90 nm and 65 nm node through copper alignment mark integration optimization

In this paper, methods for stacking ASML scribe lane alignment marks (SPM) and improving the mark performance at initial copper metal levels are discussed. The new mark designs and the theoretical reasons for mark design and/or integration change are presented. In previous joint publications between ASML and Freescale Semiconductor [1], improved overlay performance and alignment robustness for Back End Of Line (BEOL) layers by the application of stacked scribe lane marks (SPM) was presented. In this paper, further improvements are demonstrated through the use of optimized Versatile Scribe Lane Mark design (VSPM). With the application of stacked optimized VSPM-marks, the alignment signal strength of marks in the copper metal layer is increased compared to stacked SPM marks. The gains in signal strength stability, which is typical for stacked marks, as well as significantly reduced scribe lane usage, are also maintained. Through the placement of specially designed orthogonal scatter-bars in selected layers under the VSPM-marks, the alignment performance of initial inlaid metal layers is improved as well. The integration of these marks has been evaluated for the 90 nm and 65 nm technology nodes as part of a joint development program between the Crolles2 Alliance and ASML. A measured overlay improvement of ~10-15% was obtained by a strategy change from floating copper marks to stacked optimized VSPM marks.