Influence of moisture content on estimating Young’s modulus of full-scale timber using stress wave velocity

The effect of moisture content on the stress wave propagation velocity was investigated in order to estimate the Young’s modulus of full-scale timbers in an air-drying state using the measurement of stress wave propagation velocity above the fiber saturation point. Using Japanese cedar lumber, the velocity and the density under high-moisture condition and air-drying states were measured respectively; after measuring the modulus of elasticity in an air-drying state, the moisture content of each condition was measured. By performing numerical analysis on these data, the relationship between the moisture content and the rate of change of velocity of full-scale timbers was derived. This relationship was used to estimate the Young’s modulus of the timber in the air-drying state from the velocity in high-moisture condition. First, the velocity and the Young’s modulus in an air-drying state were estimated accurately from its density, moisture content and velocity under high-moisture condition. In cases where the density could not be measured, using the database of mechanical properties with the Monte Carlo simulation method, the Young’s modulus of the full-scale timber in an air-drying state might be estimated within 20% accuracy from its moisture content and velocity under high-moisture condition.