Carbonation of calcium-magnesium pyroxenes: Physical-chemical controls and effects of reaction-driven fracturing

Abstract The controlling factors and mechanisms of aqueous carbonation of primary silicates are still unclear. This precludes a better understanding of their chemical weathering in nature and is a strong handicap to implement effective Carbon Capture and Storage (CCS) strategies. Here, dissolution-carbonation reactions of two abundant Ca-Mg pyroxenes, augite and diopside, have been investigated in experiments conducted at hydrothermal conditions, in the presence/absence of different carbonate sources (NaHCO3 and Na2CO3). We show that the main reaction products are low-magnesium calcite and amorphous silica. A higher conversion of augite (∼38 wt%) than diopside (∼15 wt%) was achieved. The presence of abundant Fe and Al (and minor Na) in the former pyroxene strongly enhances the release of cations to the solution, and contributes to the formation of abundant secondary crystalline silicates as well as carbonates (Na-phillipsite and magnesium silicate hydrate, MSH). In particular, Na-phillipsite nucleates in etch pits exerting a crystallization pressure ∼100 MPa exceeding the tensile strength of augite and causing pervasive fracturing. This takes place via an interface-coupled dissolution-precipitation mechanism, despite the bulk system being undersaturated with respect to this phase. Limited reaction-induced fracturing was also observed following MSH precipitation within diopside crystals. Reaction-induced fracturing increases exposed reactive surface area and creates channels for solution flow, thereby contributing to the progress of the reaction via a positive feedback loop mechanism. Ultimately, our results help to understand differences in the kinetics and mechanisms of chemical weathering of these two abundant rock forming inosilicates relevant for CCS strategies, showing that secondary phase formation (other than carbonates) are fostered by moderately alkaline pH and the presence of alkali metals, resulting in reaction-driven fracturing that enables the progress of silicate carbonation for an effective, safe, and permanent CO2 mineral storage. We also show that under our experimental conditions the precipitation of amorphous silica and calcite cannot generate sufficient pressure as to create fracturing, an effect that limits carbonation of Mg-Ca-Fe pyroxenes.