Partial Safety Factors Assessment of Pipes With a Circumferential Surface Flaw

This paper describes the evaluation of partial safety factors (PSF’s) for parameters related to flaw evaluation of pipes which have a circumferential surface flaw, and proposes the important matter which should be pay attention in the setup of the safety factors used in flaw evaluation. PSF’s were evaluated considering randomness of flaw size, a fracture resistance curve (J-R curve) and applied loads using load and resistance factor design method (LRFD). The limit state function is expressed by fracture resistance (resistance-related parameter) and applied J integral (load-related parameter). The measure parameters in the reliability assessment are the flaw size and the J-R curve, and PSF’s of them are larger than those of applied loads. Since the material properties used in the flaw evaluation are generally set to the engineering lower limit of their variation (e.g., 95% lower confidence limit), variation of the flaw size is considered to have important role on flaw evaluation. Therefore, when setting up the safely factors used in Rules on Fitness-for-Service (FFS), it is necessary to take into consideration not only the influence of variation of loads or material strength but the influence of variation of flaw size.Copyright © 2010 by ASME