A new concept of automated manufacturing process for wire rope terminals

2020 
Abstract The products related to automotive industry need to be extremely competitive. The metallic wire ropes used to open doors in the vehicles are based on a braided wire rope provided with accessories. The more expensive is the vehicle, the more complex is the required final wire rope. In order to prevent the corrosion and reduce noise, the internal metallic cable can be coated with a polymer via extrusion. However, this coating needs to be removed from the extremities of the metallic cable, allowing the zamak injection of the mechanical terminals, preventing die casting defects. Nevertheless, the standard machines able to produce the mechanical terminals by die casting process were always prepared to work only with non-coated metallic cable. Customers demanding coated metallic cables impose the need to adapt the standard machines to this new reality. Thus, new systems needed to be added to the standard machine, allowing the metallic cable strip operation. Moreover, this operation needs to be added to the process but without repercussions on the cycle time. Different approaches were studied and tested in order to find the best solution. The new device was designed and produced, allowing its test in real conditions. The system based on just one blade did not show satisfactory results, being necessary the use of a system based on multiple blades. The new device, when connected to the standard machine, allows to produce wire ropes up to 2.5 meters long, striped in both sides, letting the die casting injection of the zamak terminal in one extremity, with a cycle time of 7 seconds (1000 wire ropes per hour, as they are produced in couples).
    • Correction
    • Source
    • Cite
    • Save
    • Machine Reading By IdeaReader
    20
    References
    1
    Citations
    NaN
    KQI
    []