Simulation study of induced EMFs and the suppression during SST-1 start-up

Abstract Steady State Superconducting Tokamak (SST-1) comprises of various copper and superconducting coils for generating magnetic field for initiation, providing equilibrium and shaping of plasma in tokamak. In this paper, an attempt is made to study the induced EMF in superconducting poloidal field coils (PF coils) due to fast ramp down of current in ohmic transformer copper coils (OT coils) for SST-1 plasma initiation. The fast ramp down of current, from few kA to zero amperes in just 50–100 ms in OT coils, is required to achieve plasma breakdown and ramp up of plasma current in tokamak. However, it induces nearly 5 kV EMF in one of the SST-1 PF coils that can damage the coil insulation and also bias negatively the electronic switching of power supply. It is necessary to maintain induced EMF below 1 kV in all PF coils for safe operation of SST-1. The induced EMF up to 1 kV can be clamped without any need of protection and circulating current. If the induced EMF is in excess of 1 kV, then it has to allow the circulation of current through RC network for coil protection from overvoltage. These circulating currents in PF coils will affect the shaping of plasma. In this paper, the induced EMF in PF coils are simulated using MATlab simulink for a typical SST-1 current profile of OT coils. Further, this simulation study is used to design the protection system for PF coils. In this paper, the worst-case induced EMF scenario is considered by excluding the effect of passive elements like vacuum vessel and cryostat on mutual coupling parameters. However, the implementation of the EMF suppression scheme need more elaborated study with considering the accurate penetration depth of vacuum vessel, which will reduce the induced EMF in PF coils. The effect of circulating current on equilibrium and plasma shape is estimated and a scheme to correct this by driving current in one of the PF coils is developed.