Polymers in Concrete – The Shielding against Neutron Radiation

Concrete has been used as a shield against high-energy photons (gamma) and neutrons since the beginning of use of nuclear reaction in energy, medicine and research. State of knowledge in shielding concrete technology is that while in case of protection against gamma radiation an increase in density caused by change of aggregate type for heavy-weight one is usually an efficient solution, the protection against neutrons is more complex. It is due to the differences in interactions of neutrons with the matter, depending on their kinetic energy and cross-sections for different reactions of the component atoms of the cement paste and the aggregate. The paper presents the results of the project NGS-Concrete - New-Generation Shielding Concrete. The aim is to design the composition of concrete against ionizing radiation, achieved by the use of experiment based on multi-criteria optimization of materials supported by the Monte Carlo simulations. Better concrete is the one that absorbs more thermal neutrons and slows down more fast neutrons at the same time. In the paper both results of Monte Carlo simulations and experimental studies on ordinary and heavyweight concrete containing epoxy polymer additive are presented. Close values of thermal neutron attenuation coefficients proved good accordance between simulation and experiment. The final conclusion is that epoxy resin is an efficient additive for neutron shielding concretes improving its ability to protect mainly against low energy neutrons. In experimental measurement there has not been observed an improvement of fast neutron attenuation due to increase of hydrogen atom content introduced with epoxy.